Anyone got a clean way to pop the bottom cover off a Ninja Blast?

[Thomas Martinez]

Quick one for anyone who's poked around inside one of these Ninja Blast portable blender. After doing some research on how to get the bottom cover off the motor base to access the battery and read the serial number, there's limited information available. Most tutorials just tell you to "remove the bottom cover" but dont illustrate the steps to doing so.
As with most products, the bottom cover is the gateway to the rest of the device. If youre ever curious how to do this, has anyone done it before? Are the screws hidden beneath the rubber foot pad? Or is there a clip ring to consider in addition to the Phillips screws? I've seen mentions that small Phillips screws sits under the rubber pad but I'm not certain if that's all that's required to remove the bottom cover.
Is the charge port wire long enough to simply lift the bottom cover perhaps an inch or two? Or do you have to be ready to disconnect the wire from the charge port the moment you remove the bottom cover?
There seem to be limited information online regarding how to open these up so any information on how to do it safely (without breaking the plastic case) would be of great help to others in the same situation with these cheaper ($40) kitchen blender.

 

[My Little Racc]

Did mine like 2 months ago. Peel the rubber foot pad off the bottom of the blender slowly. There's 4 phillips screws under the rubber pad. Once the screws is out, the bottom cover still feels like it should come off but there's a lip around the edge of the cover. Use a plastic pry tool to pop it off. There's no clip ring on these.

 

[Biblical Chicken]

The wires from the charge port on the blender has enough length so that you can lift the bottom cover up by an inch or two. Dont yank the bottom cover up too much though. Just flip the blender sideways and you can expose the charge port connector if you want to disconnect it.

 

[M.C. Escher's]

why are you guys spending time on a 40 dollar blender lol just buy a new one

 

[Neo]

Did mine like 2 months ago. Peel the rubber foot pad off the bottom of the blender slowly. There's 4 phillips screws under the rubber pad. Once the screws is out, the bottom cover still feels like it should come off but there's a lip around the edge of the cover. Use a plastic pr…

wait, what kind of plastic pry tool are we talking about here? Will a guitar pick work or do we need to purchase one of those ifixit blue spudger tools? Also, will the rubber foot pad just rest back on with the original adhesive or is there something else needed?