wrangler deploy w/ DO containers: "settings were not fully applied" and rerunning it just loops

Feb 10, 2025
2
0
1
doing what the message says and running it again doesnt help

The Worker version was deployed, but its Durable Object-managed Container application settings were not fully applied. Re-run the same `wrangler deploy` command to retry and finish deployment.

upload is fine, then wrangler polls the new version id for about 2.5s, gets 404s and bails. each rerun makes a new version so its the same race again

supposedly `wrangler versions deploy <id>@100% --yes` afterwards finishes the container part

kinda doubt thats more than timing luck